SOLARO QR1

XILICA SOLARO QR1 – a multifunctional audio processor with an open architecture, built on the 8-slot chassis of the XILICA SOLARO family. The model comes pre-installed with a module supporting 4×4 channels for the Dante audio network and is equipped with eight slots for installing I/O modules. In addition to analog and digital audio modules, the chassis allows for the installation and configuration of GPIO and relay modules, enabling the transmission of not only audio data but also control signals over IP networks. Control is managed via the Xilica Designer software. The open and flexible architecture allows the user to create not only the required audio signal processing paths and apply standard processing effects to them but also to use complex intelligent modules utilizing feedback. The optional AEC module allows for acoustic echo cancellation for up to 8 channels simultaneously with a maximum delay duration of 250 ms. The processor can act as a control controller for other devices and is equipped with scheduling capabilities. The use of XTouch hardware and virtual controllers allows for quick creation of control interfaces for end users. The device is housed in a compact 1RU high chassis and can be installed in a standard 19″ rack. The front panel is equipped with status indicators, a connector for an external power supply, an RJ45 Ethernet port, and an RJ45 Dante interface port. The device supports PoE and can be powered directly from a PoE Ethernet switch.

– 40-bit XILICA X8 floating-point DSP processor
– 32-bit analog-to-digital/digital-to-analog converters
– Sampling frequency: 48 kHz
– 8 slots for module installation
– Built-in 4×4 Dante module
– Modular architecture
– Flexible configuration
– Remote Ethernet control, support for Xilica Designer software, XTouch
– Optional AEC up to 8 channels/100ms, 4 channels/250ms

Number of slots: 8
Processor: 40-bit floating-point
Sampling frequency: 48 kHz
Introduced delay: 4 ms
Interface connectors: RJ45 Ethernet (PoE), RJ45 Dante
Power supply: 12 V DC, 2 A
PoE: IEEE 802.3af, Class 0
Dimensions: 108 x 44 x 152 mm
Weight: 1 kg

8 slots for expansion cards / 4×4 Dante channels by default

+12 V DC / 2 A external power supply or PoE+ (Power over Ethernet Plus)

<44 BTU/hr (Heat dissipation)

Control via Ethernet (Xilica Designer software), 40-bit floating-point processor